Arctic Spa Glacier Specifications download pdf (Page 11)

CAUTION!

Do Not turn on power

to the spa until the spa

is ﬁlled to the required

level. Running the spa

pump without water

could cause immediate

damage and invalidate

your warranty!

When the water temperature climbs above 85ºF (29ºC), proceed to the next step.

9) Test and Adjust Sanitizer level (Chlorine ideal 1 - 3 ppm or Bromine ideal 3 - 5 ppm).

10) Rotate diverters to centre position and press “Pump 2” button on topside control

panel for 5 seconds to activate the “Boost ﬁltration system”. When this system is enabled,

“BOO” is displayed on the screen. This will give 45 min of circulation and ﬁltration to

disperse the chemicals.

11) You can set the temperature (between 38°C and 40°C or 100°F to 104°F) by pressing the

TEMP ( ) and TEMP ( ) buttons on the control panel. The spa will normally come

up to temperature within 16 to 24 hours. Replace the spa cover while the temperature is

reaching the set point.

IMPORTANT: For safety, you can lock your desired temperature setting. Refer to the Topside

Control Panel section for details.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

No comments

Arctic Spa Glacier Specifications Page 11