Arctic Spa Glacier Specifications download pdf (Page 10)

Startup Procedures

IMPORTANT:

Your Arctic Spa

has been thoroughly tested during the manufacturing process

to ensure reliability and long-term customer satisfaction. Before ﬁlling the spa,

wipe the spa shell clean with a soft rag.

The following instructions must be read and followed exactly to ensure a success-

ful start-up or reﬁll.

1) Ensure the electrical connections have been made in accordance with this manual.

2) Ensure all O-Rings have been installed into unions and unions have been tightened sufﬁciently.

3) Ensure all ball valves are open, and the drain has been closed.

4) Using a garden hose with a pre-ﬁlter, ﬁll the spa with pre-ﬁltered water to the bottom of the

pillows (or approximately 6”, 15 cm above the base of the ﬂoating weir).

5) Once the spa is ﬁlled to the proper level, turn the power to the spa on, by turning on the GFCI

breaker in your panel.

6) The jet pump, heating system and all internal plumbing will achieve a partial prime as the spa is

ﬁlled. To check the operation of the jet system and to remove any remaining air from the

plumbing system, follow these steps:

a) All Models: Push the Pump 1 button a second time to turn the pump to high

speed. Allow to run for 1 minute.

b) Signature, Ultra, and Legend series: Push Pump 2 button also. This pump runs at high speed

only. Run for one minute.

c) Legend series only: Push Pump 3 also. This pump runs at high speed only. Run for one

minute. Once the jet system is fully operational (as indicated by strong, non-surging jets),

priming of the spa is complete. Push each Pump button once to turn the pumps off.

IMPORTANT: Weak or surging jets are an indication of a low water level, a clogged ﬁlter cartridge,

or an improperly adjusted ﬁlter weir.

7) Adjust the chemicals and balance the water according to your dealer’s instructions. A guideline is

also included in this manual, under the Water Maintenance Section.

8) Set the temperature control to the desired temperature (between 100ºF and 104ºF (38ºC and

40ºC), then place the insulated cover on the spa and allow the water temperature to stabilize

(approximately 16 hours). Make sure you secure the cover in place using the cover locks.

Periodically check the spa water temperature.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 31 32

No comments

Arctic Spa Glacier Specifications Page 10