Arctic Spa Avalanche Specifications download pdf (Page 30)

Troubleshooting Spa Problems

1. Nothing functions: The RCD Breaker has tripped or there is a power failure. Test RCD

Breaker. Turn breaker back on and see if spa powers up, if not contact your factory authorized

dealer.

2. Spa does not heat: Check to see if the heat indicator is on or there are any error messages on the

topside control panel. If the heat indicator is on and no error message appears contact your

factory authorized dealer.

3. Poor Jet Pressure: First check to see that the jet(s) are turned on fully. Check your ﬁlter to see

if it’s clogged or dirty. Next, check to see if the jet(s) are obstructed or if the venturi air dial is

turned on. Finally, check to see if the jet(s) are surging. If so, your pump is cavitating (sucking

in air). This usually occurs when the water level is too low and can be solved by adding water to

the spa. If the problem still persists, contact your factory authorized dealer.

4. Light is not functioning: Follow the LED replacement section.

5. Spa comes on by itself: This function is normal when heating and ﬁltering. No action required.

6. Spa doesn’t drain completely: The spa is drained by gravity. It will not always drain fully. It

is not necessary to drain the spa in its entirety except when winterizing the spa. If you wish to

remove the last little bit of water, we recommend you vacuum it out with a wet/dry vacuum.

1 2 ... 25 26 27 28 29 30 31 32

No comments

Arctic Spa Avalanche Specifications Page 30